How to open dried nail polish: 3 ways

Today, manufacturers produce a diverse palette of colors for every taste and wallet. However, many girls prefer to be content with one shade and do not change it. Very often, a bottle of varnish dries at the most inopportune moment, which puts beautiful ladies in an awkward position. Soon it's time to go to the event, and the nails have not yet made up. Do not get upset, consider the effective technology to solve a pressing problem.

Hot water

1. Before starting a full-scale operation, try a simple technique. Turn on hot water to make it flow. Wear rubber gloves and hold the bottle in your hand. Quickly place the neck (drying place) under the tap, then wrap the tube with a towel. Try to unscrew the cover, in cases with a slight curing these measures will be enough.
2. If the first technology was unsuccessful, use the following recommendations. Turn on hot water to make it flow in a thin stream. Wear thick rubber gloves, grab a polish bottle in your hand. Substitute a lid under a stream of water, wait about 2 minutes. Throughout the procedure, slowly turn the tube so that it warms up evenly. Make sure that hot water does not fall on the glass container, otherwise the varnish dries in the bottle itself. As in the previous case, wipe the cover with a towel and try to unscrew the tube. Under the influence of high temperatures, plastics will expand a little, due to which the lid will be easier to “sit” on the neck.

Gum for banknotes

In most cases, the problem with the opening of varnish is the subtlety of the cover. It is impossible to embrace it in such a way as to scroll strongly enough. The usual office stationery for banknotes will help to correct the situation. Twist them in half, put them on your fingers, then wrap tightly around the cap of the bottle. If necessary, use a few pieces to get a tight grip.You can even open those bottles that are equipped with a sharp and thin cap.

Nail polish remover

Sometimes it happens that after painting the nails, the ladies do not completely close the tube. Soon it turns over on its side, the content flows out and clogs the area where the lid is connected to the neck. Because of this, it becomes problematic to open the bottle; here it is necessary to use several stages.

To begin, open the hot water, adjust the thin stream. Wear protective rubber gloves, put the tube under the water, wait about 1.5 minutes. After that, pour pure acetone into the container or use the product that contains it. Put the lacquer cover in a bowl so that the joint is tightly covered, wait about half an hour. In order not to pour a lot of money, put the bottle on its side, periodically overturn it.

When the dried lacquer softens, remove the excess with a sharp object, around which the gauze is wound. Suitable nail scissors or a kitchen knife. Now turn the tube upside down, pour acetone into the hole between the lid and the bottle, wait at least 10 minutes,periodically pour the composition. At the end of the period, try to unscrew the tube, if necessary, repeat the action again.

Preventive actions

Now process the inside of the lid. Pour acetone into it, wait 5 minutes and pour it. Pour again, put a cotton swab in there and clean the inside of the thread well. At the end of the action, rinse the cover with clean nail polish remover, screw it back into place.

Important!
You should not leave a tube of varnish in the half-open state in the hope that the lid will not stick in the future. In this way, you only contribute to the rapid drying of the contents.

Do not resort to mechanical methods of exposure that involve the use of sharp objects.Do not attempt to open the cover with a knife, scissors, screwdriver or pliers. Making such attempts, you only ruin the thread. You should not beat the bottle with varnish on the table, the technique is effective in the case of homemade pickles, but not with cosmetics.

Video: what to do if nail polish thickened or dried